Small-sized wind generating station as the way

to feed low power absorbing machines

(Mała elektrownia wiatrowa jako sposób zasilania urządzeń o małym poborze mocy)

• 
  Project made under the superision of Sławomir Czubaj
• Project made by Paweł Stefaniak and Łukasz Pawłowicz

The propeller is built of 4 propeller- blades, which are fixed to the pipe and to the cross-bit at an angle of 300
Inside the cross-bit there is a hole sized ¤ 16. The cross-bit is put on the screw wire ¤ 16 and is safed by two nuts. The same of putting all parts together is used while building the aluminium wheel used as a pulley. The wire is attached to the inner side of bearings. To make the bearings move fluently there is a sleeve made of the pipe ½ . The whole part is safed by nuts. The outer part of bearings is placed in the pipe 1 ½. Thanks to it the whole construction can move fluently. The generating station consists of several main parts which can be easily rebuilt. It is important if you want to use this genetaring station while travelling. The generating station consists of: the base, the stand placed in the middle of the base, the alternator attached to the stand by the wedge-shaped belt. The alternator moves and produces energy that is saved in the storage battery via¤10mm2x300mm wires with connectors. Additional ¤ 2,5mm2x300mm wire is used to make the storage battery work.The transformator of 12 V voltage is used to give the final voltage of 220/240 V.